Problem Description:The side strips are broken.
Reason Analysis:Replace broken side strips
Solutions
Steps to replace the side strips:
Step 1: Turn the treadmill sideways first and take off the clips of riser under the right side. Then unscrew the screw and unplug the communication cable terminal
Step 2: Remove the decorative cover under the left side of the riser, and use a socket wrench to unscrew the hexagonal screw to pull out the tie rod. Take the riser out.
Step 3: Turn the treadmill sideways, remove the screws under the motor cover, then find the screws used to fix the rear cover on both sides, take off this screw first, and take off the rear cover on both sides. Then turn the treadmill back
Step 4: Pull out the upper side strip that needs to be replaced, remove the upper motor cover, remove the fixing buckle and unscrew the screws used to fix the upper end of the side strip. Next, turn the treadmill over, take off the screws used to fix the side strip at the bottom, and then pull out the side strip.
Step 5: Install the new side strip: fix the screws at the bottom of the side strip, put the treadmill in the right place, tighten the screws used to fix the side strip, install the side strip fixing piece, and finally install the top side strip.
Step 6: Put on the motor cover, then turn the treadmill sideways, tighten the screws used to fix the rear end cover on the left and right sides, tighten the screws used to fix the motor cover, then turn the treadmill over。
Step 7: Put down the riser, use the tie rod through the left and right risers, fix it with screws, and put on the decorative cover
Step 8: Turn the treadmill sideways and connect the communication line port on the lower end of the right riser. Fasten with snaps and install the screws